Xinje XS Series - Appendix; Appendix 1. PLC Function Configuration List; Appendix 2. Q&A

45
Appendix
Appendix 1．PLC function configuration list
This part is mainly for the convenience of users to check the function configuration of products of various series
models. Through this table, it is easy to judge the selection of product models.
For detailed introduction of the following functions, please refer to XS series PLC user manual [motion control]
and XS series PLC user manual [software].
○ user select × not support √ support
Series
Clock
USB
RS232
RS485
RJ45
CAN
port
Communication
Expansion
module
HSC channel
External
interrupt
Ethernet
EtherCAT
Incremental
mode
AB phase
XSDH-60A32-E
√
×
1
1
2
×
√
16
4
4
14
XS3-26T4
√
×
1
2
2
×
√
16
4
4
6
XSLH-30A32
√
×
1
1
2
1
√
16
4
4
10
Appendix 2. Q&A
When running or debugging PLC, users may encounter some difficult problems due to lack of experience. This
part mainly aims at the problems that users are most likely to encounter, and puts forward solutions for users'
reference.
Q1: Why can't PLC communicate with peripheral devices?
A1: Communication failure is generally summarized as the following problems:
(1) Communication parameters: the communication parameter settings of PLC communication port and
peripheral equipment may be inconsistent.
(2) Communication cable: the connection may be incorrect or the contact may be poor. The user can replace the
communication cable and try again.
(3) If the above are excluded, please contact our company.
Q2: How long can the battery power in the PLC be maintained?
A2: Generally, it can last for 2-3 years.
Q3: Why can't connect to the PLC device?
A3: Failure to connect PLC is generally summarized as follows:
1. Confirmed as XS series products (XD and XG series products have been regarded as XS series in many
cases).
2. Confirm that the upper computer engineering equipment is consistent with the target equipment, otherwise
the equipment will not be scanned.
3. Confirm whether the IP addresses of both parties are the same network segment and can be ping. If the IP
address cannot be confirmed, try to set dial 1 to ON and restart the device (the initial IP address is 192.168.6.6
after power on), and then scan and connect again. If the network segment is the same but the subnet mask is
different, the device cannot be scanned, but you can directly enter the IP address to connect the device.