Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751
40
Your XLT oven is constructed of stainless steel. Most commercial cleaning agents may be
used safely on all stainless steel surfaces. Check application restrictions on product label prior to
usage. Observe recommended precautionary and safety measures as dictated by the product manu-
facturer. Do not use caustic cleaners on the conveyor bearings.
Do not use abrasive cleaners or abrasive pads as they can scratch stainless steel surfaces.
Areas with heavy buildup should be sprayed and allowed to soak for up to 5 minutes prior to wip-
ing clean. Always wipe with the “grain” of the surface to maintain appearance.
Do not use caustic cleaners on the control panel and/or electronic components. Only use
cleaners compatible with Lexan® on the face of the conveyor control.
The most critical item to be cleaned is the filter on the fan. The filter is held in place by the
stainless steel fan guard/filter mount and can be washed several times. Regular cleaning of the fil-
ter is important to maintain air circulation within the control box. Depending upon store condi-
tions, this filter should be cleaned weekly or as it gets clogged with dust. Please contact XLT Ov-
ens for replacement parts.
Cooling Filter Maintenance
1. When cooling filters need to be cleaned a alarm will appear on the LUI saying “FILTER”.
2. Press the MENU button to enter the “FILTER RESET” screen.
3. Once the filter is cleaned, press ENTER to reset the filter timer. This will take you to another
screen which will show you the timer back at 00:00 and will exit after 5 seconds.
4. If you wish to bypass alarm press the MENU button and it will clear the alarm for an additional
2 hours. Then the “FILTER” alarm will appear again.
OVEN CLEANING
Fan Guard / Filter Holder
Fan Filter
To Next Page
Loading...
