6
5. Assemble your XMG OASIS
1. Read the user manual before operating XMG OASIS.
2. Keep the original box & packaging safe – do NOT throw it away!
3. Check the contents for visual damage. Check if the connectors are
firmly attached to the water tubes on both ends.
4. Put the device upright on the desk, with the power button at the top.
5. Gently unscrew the hexagon water stoppers on the XMG OASIS main
unit. Do not throw them away, you will need them again later. Keep
them safe in the original box of XMG OASIS.
6. Gently attach the black connectors of the water tubes to the main
unit by carefully tightening the screws. Avoid twisting the tubes
during this process. Stop tightening when you encounter resistance.
⚠ Do NOT use a wrench or any other tool to undo or tighten connectors. Im-
proper force may damage the tube sockets, leading to long-term water
leaks.
Gently remove the hexagon water
stoppers by loosening the screw.
Keep them safe after removal!
Make sure the connectors are attached firmly, but don’t squeeze them
too hard. Stop turning when you notice the resistance is getting
stronger. Do NOT use a wrench for this step – do it by hand!
To Next Page
Loading...
