16.0
ID ADDRESS SELECTION
ID Address Instructions
1.Setting ID address
1、Access control panel function by pressing MODE until 【ID】 is displayed.
2、Press ENTER, increase or reduce ID values by pressing UP/DOWN between 01 and 66.
3、Press MODE to exit.
2. Enable or disable ID 【SET】-【IDSW】-【ON-OFF】
For every DMX512 address the user can set 66 separate ID addresses. ID addressing is a secondary function in DMX512
mode. In DMX512 Controller Mode, the user can simultaneously control the individual DMX address of all lights, and can
control the lights which have separate ID address in independent DMX512.
Select STAG channel on fixture's control panel (Please refer to DMX512 Channels Selection). The figure above shows a
simple DMX layout which has used three units at each DMX address. The three units have different ID addresses. In the
DMX address: 001, the user can control the first three lights simultaneously. When using channel 12 select the channel
number is 020-029 and ID Address=02, the controller can control the second light individually. When using channel 12
select the channel number is 000-010 and ID Address=00, all the lights are in common use at the same DMX address.