Easy Setup
Guide
What’s in the Box
Whole Home
Wi-Fi Unit
Power Cable
Yellow Cable
Red Cable
The Xplore Whole Home Wi-Fi network enables superior coverage in every room
in bigger homes by deploying one or more Whole Home Wi-Fi Units in distant
locations to extend your Wi-Fi signal.
Connecting your Whole Home Wi-Fi Units to the Wi-Fi Hub:
If you already have Xplore Whole Home Wi-Fi Units in use, you will need to
perform a factory reset rst using the Reset button on the back (hold for 10
seconds, wait 3 mins for it to power on fully). Repeat for all units.
1
Plug the Whole Home Wi-Fi Unit into a power outlet near the area you want
to cover with Wi-Fi. Wait 3 minutes for it to start up. LED Light at the front of the
device would be solid Red while it is booting up.
2
Press the WPS button on the back of the Xplore Hub unit, and then the blue
WPS button on the front of the Whole Home Wi-Fi Unit. The light on the Whole
Home Wi-Fi Unit will turn blue, once it has synchronized. If it does not turn solid
blue but shows ashing blue instead, the unit may need to be placed closer
to the Hub.
3
Repeat for the other Whole Home Wi-Fi Units if applicable. If the LED light of
the Whole Home Wi-Fi Unit ashes in red, this indicates failure to sync with the
Hub. Repeat steps 1-3 again.
Your Wi-Fi name and password will still remain the same in all areas covered by
the Whole Home Wi-Fi Units.
For instructions on how to install your Wi-Fi Hub, please refer to the Hub 5 easy setup guide.
In the Box
You will find the following items included:
Xplornet WiFi Unit
AC Power Adapter
RJ-45 LAN Network Cable
RJ-45 WAN Network
Cable
Ifanypartsaremissing,pleasecontactXplornet Support
By Email: support@xplornet.com
By Phone: 1-866-841-6001
Modem
Xplore
Hub 5
Modems may vary
in appearance
Whole Home
Wi-Fi Unit
To Next Page
Need help?
General
