DIRTCARPET
28
6. SHOCK ABSORBERS
352460 PIVOT BALL 5.8mm (2)
363241 BALL UNIVERSAL 5.75mm WITH BACKSTOP (2)
368013 COMPOSITE SHOCK PARTS FOR 2 SHOCKS - BIG BORE
368032 SHOCK PISTONS - COMPLETE SET - DELRIN - BIG BORE
368042 COMPOSITE SHOCK BUSHING & SHIM (2+2)
368049 ALU SHOCK ADJUSTABLE NUT - BIG BORE (2)
368140 ALU LOWER SHOCK BODY CAP (2)
368201 REAR SHOCK ABSORBERS - BIG BORE - SET (2)
368222 ALU SHOCK BODY - BIG BORE (2)
368223 XT2/XT4 ALU REAR SHOCK BODY - BIG BORE (2)
368261 XT2/XT4 REAR HARDENED SHOCK SHAFT 56mm (2)
368262 REAR HARDENED SHOCK SHAFT 47mm (2)
902205 HEX SCREW SH M2x5 (10)
965023 E-CLIP 2.3 (10)
363241
902205
368032
965023
368261
368223
970080
973030
368140
368049
368013
368013
970131
368262
965023
368222
970150
368032
328182
328282
368013
368042
352460
BAG
328182 FRONT BIG BORE CONICAL SPRING-SET L=49mm - 2 DOTS (2)
328282 REAR BIG BORE CONICAL SPRING-SET L=67mm - 2 DOTS (2)
970080 O-RING 8x1 (10)
970131 O-RING 13 x 1.0 (10)
970150 O-RING 15 x 1.5 (10)
973030 SILICONE X-RING PRE-OILED 3x2 (8)
#104004
HUDY AIR VAC - VACUUM PUMP
- 1/10 OFF-ROAD
2.5mm / ø1.6mm
2.5mm / ø1.6mm
2.0mm / ø1.6mm
2.0mm / ø1.6mm
2.0mm / ø1.8mm
2.0mm / ø1.8mm
2.5mm / ø1.8mm
2.5mm / ø1.8mm
2.5mm (Create custom holes)
(0mm - use required drill pin)
2.5mm (Create custom holes)
(0mm - use required drill pin)
Thin Shim
Thin Shim
Thick Shim
Thick Shim
These pistons can NOT be used in shocks without
making the custom holes by yourselves.
+4mm
#368011
COMPOSITE SHOCK BALL JOINT +2mm & +4mm (2+2)
+2mm
#368033
PRECISION GROUND SHOCK PISTON
BLANKS 2.5MM - BIG BORE (4)
#368034 PRECISION GROUND SHOCK
PISTON BLANKS 2.0MM - BIG BORE (4)
PISTONS DETAIL
#368054
ALU SHOCK CAP-NUT - BIG BORE (2)
#368021
ALU SHOCK SPRING RETAINING COLLAR (4)
#368022
ALU SHOCK SPRING RETAINING COLLAR -2mm (4)
#368023
ALU SHOCK SPRING RETAINING COLLAR -4mm (4)
1mm 2mm 3mm
#306219
DOWNSTOP SHIMS
THICKER shim used, GREATER
downstop is achieved.
368032
SHORT
SHORT
LONG
LONG
To Next Page
Loading...