DIRTCARPET
4x
4x
30
6. SHOCK ABSORBERS
Install the pivot balls with
Professional Multi Tool (HUDY #183011).
There are two different thickness shims, use them as shown.
Use the same procedure when building both front and rear shocks.
UPSTOP "C" SHIM
EXTREMELY
IMPORTANT
DO NOT PUSH the shock rod
straight through the lower shock
body assembly; X-ring damage
may result.
SHORT
SHOCK SHAFT
INITIAL SETTING
(0mm)
INITIAL SETTING
(No shim = 0mm)
INITIAL SETTING
(0mm)
LONG
SHOCK SHAFT
TWIST THE SHOCK ROD
through the lower shock
body assembly.
INCORRECT
CORRECT
970131
O 13x1
970080
O 8x1
DETAIL
2x2x
2mm
1mm
SHORT SHOCK BODY
2x
SHORT SHOCK BODY
LONG SHOCK BODY
2x
LONG SHOCK BODY
THIN Shim
THICK Shim
Silicone X-ring
Silicone X-ring
1mm 2mm 3mm
Always use same shim thickness
on right and left side to achieve
same downstop.
#306219 DOWNSTOP SHIMS
IMPORTANT
Add downstop shims to limit suspension travel.
Thicker shims increase downstop and reduce droop.
Thicker downstop shims reduce suspension travel.
36mm
28mm
4x
+4mm
#368011
COMPOSITE SHOCK BALL JOINT +2mm & +4mm (2+2)
+2mm
4x
973030
X 3x2
8x
4x
970150
O 15x1.5
4x
To Next Page
Loading...