Xtend Porch - Step 6: Adjust Pole Height; Step 7: Secure Spreader Bars with Poles; Step 8: Raise and Tighten Porch; Step 9: Secure Porch to Ground

OUTDOORS Porch
Setup Instructions
Adjust 4x 9ft poles to the same height as the rear of the anti-ap kit,
and front of the anti-ap kit.
STEP 6
Insert the 9ft pole spigot through the eyelets on the two spreader bars
and through the canopy corner eyelet. Repeat for all bars.
STEP 7
Rear of anti-ap
kit height
Front of anti-ap
kit height
CANOPY CORNER EYELET
SPREADER BAR
SPREADER BAR
9ft POLE
Raise the porch and adjust the poles and spreader bars until all are tight.
STEP 8
Secure the springs to the ground with pegs and attach rope loops over
9ft pole spigots on the top of your porch.
Tighten by pulling the wooden handle.
STEP 9
Attach C-Clip rafter between the front and rear spreader bars, and
adjust the length using the handle on the C-Clip rafter.
Your porch is now ready to use.
STEP 10
CANOPY
REAR SPREADER
BAR
FRONT SPREADER
BAR
C-CLIP RAFTER
www.xtendoutdoors.com.au
1300 783 776