Xtool M1 Ultra - Page 18

Indicator status
Buzzer status Device status
Solid white /
Standby, not connected to XCS
(at AP mode)
Sounding once Standby, connected to XCS
/ Sleeping, not connected to XCS
/ Sleeping, connected to XCS
/ Firmware updating
/
Processing area marking on XCS /
Framing / Processing
Sounding once Ready for framing / Ready to process
/ Task paused
Sounding once
The lid is open or not fully closed during
operation.
Keeping sounding
Flame detected (small flame) / Device
shaken
Keeping sounding Flame detected (large flame)
Sounding three times Exceptions occur
Solid purple
/
Standby, not connected to XCS
(at STA mode)
Solid light blue
Breathing white
Breathing purple
Blinking purple slowly
Solid green
Blinking blue slowly
Solid blue
Blinking yellow
Blinking yellow
Blinking red
Blinking yellow
Sounding three times Major exceptions occur
Blinking red
Indicator description
16