13
FAQ
FCC statement
Declaration of conformity
After-sales services
When I use the hot foil pen, the hot foiling result becomes poor. Why?
The performance of the hot foil pen may be affected by the following three
factors.
1. Processing temperature for foil paper. The processing temperature for foil
paper varies according to type. When you use foil paper from other brands with
xTool hot foil pen, the hot foiling results may not be satisfactory. It is
recommended to use the foil paper provided by xTool.
2. Ambient temperature. Using the hot foil pen in a cold environment may cause
it to heat up slowly or fail to reach the appropriate processing temperature.
Therefore, it is recommended to use the hot foil pen indoors with a temperature
between 10°C and 35°C.
3. Condition of the hot foil pen. If your hot foil pen is damaged, contact our
after-sales customer services.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
For technical support, contact us at support@info.xtool.com.
For more information about after-sales services, visit support.xtool.com.
Hereby, Makeblock Co., Ltd., declares that this product is in compliance with the
essential requirements and other relevant provisions of Directive LVD 2014/35/EU
and the RoHS directive 2011/65/EU.
To Next Page
Loading...