Xtralis ADPRO FastTrace 2 series User Manual

Hardware Installation Manual ADPRO
®
FastTrace™ 2 Series
102 21790_05
24 Maintenance
24.1 Replacing the Filters
It is essential that the filters are regularly cleaned and – when needed – replaced by new filters.
You need an Allen wrench (3 mm) to remove the front plate of the FastTrace 2 server. Remove the screws
indicated by the white arrows on the image below and remove the front plate. Remove the dirty filters and
replace them by clean ones (or new filters). Make sure the filters are placed straight with the edges behind
the chassis before putting the front plate back in place. Make sure that there is no filter material stuck
between the front plate and the chassis!
Put the screws back in place. Take care that the USB slot (indicated by the red arrow) is accessible.
24.2 Cleaning the FastTrace 2 Server
Caution!
Do NOT clean the device with water or any corrosive products. Use only dust cloths and wipes
to clean the outside.

Xtralis ADPRO FastTrace 2 series Specifications

General

Brand	Xtralis
Model	ADPRO FastTrace 2 series
Category	Security System
Language	English