1.
Make sure that all of the exposed bolts and screws are tightened.
2.
Raise the kickstand to its upright position.
3.
Make sure the engine is running.
4.
Put one foot on the deck of the motorcycle. While pushing off with the other foot, gently rotate the
THROTTLE toward the rider on the right side of the handlebars. The motorcycle will begin to move on its
own power. Control the speed by rotating the hand throttle either towards the rider or away.
BRAKING
1.
To brake, release the hand throttle and depress the hand brake levers (on the left side of the
handlebars).
Stopping/Shutting down
2.
Gradually decrease the engine speed to idle and turn off the kill switch on handlebar tube. This will
turn the engine OFF.
NOTE: If the lever Is pulled aggressively, the locking spring may become stretched and then the
steering will not lock Into position, It Is also advisable to efl5ure the handlebar locks firmly, prior to riding.
WARNING:
■
Always shut the engine off before refueling.
■
Slowly open the fuel tank, so that possible over-pressure disappears.
■
Before fueling, clean the tank cap area carefully, to insure that no dirt falls into the tank. Make sure that
the fuel is well mixed by shaking the container.
■
Tighten the fuel cap carefully, after fueling.
■
Always move the unit at least 1O feet from the fueling area before starting.
5
To Next Page
Loading...