5. Use # 10x1-1 / 4 screws to fix other three treads. Then put aside for later.
6. Assemble handrails to the platform, center cover cap opening on side of handrail where platform was
just attached. Using a rubber mallet/hammer, tap on cap until the cap is flush with handrail.
7. Aach handrails by pushing them down over the holders.
8. Secure handrails to the legs with #10 1-1/4 screws
Fix the treads to the left and
right fixing strips with screws.
Pushing them down
over the holders
Step 7
Screw
Tighten with two screws for
both sides
Cover Cap
Deck Platform
Handrail
Step 8
3
To Next Page
Loading...