3. Install the junction box in one of the following correct positions.
Correct Incorrect
4. Use a torque wrench to tighten the screws of the pump body.
The torque must be 5 Nm (44 lbf.in).
4.1.5 Insulation housing
4.1.5.1 Requirements
NOTICE:
Improper installations shown above can cause the pump to fail
prematurely and create an electrical hazard and/or damage
caused by water leakage.
4 Installation
14 Ecocirc+ 20-18 Installation, Operation, and Maintenance Manual
To Next Page
Loading...
