Proper horizontal and vertical installation Improper installation with a sharp
bend
Fasteners
WARNING:
• Only use fasteners of the proper size and material.
• Replace all corroded fasteners.
• Make sure that all fasteners are properly tightened and that there are no missing
fasteners.
Install with P-installation
In the P-installation, the pump is installed on a stationary discharge connection, and
operates either completely or partially submerged in the pumped liquid. These
requirements and instructions only apply when the installation is made according to the
dimensional drawing.
You can inspect the pump by hoisting it up along the guide bars without disconnecting it.
Figure 3: P-installation
Installation
Flygt 3060 Installation, Operation, and Maintenance Manual 13
To Next Page
Loading...
