Xylem Flygt FGC 421 - 8.4 Common procedures; 8.4.1 Modify the start and stop levels

Menu Action
GP Input Usage Select:
– None
– Low Level Float
– Station Overflow
– Personnel Alarm
Phase Mode – Single Phase
– 3 Phase
Voltage Select and change to the correct value.
Full Load Current Select and change to the correct value.
This value is set for both the pumps in a two-pump station.
Sensor Type Select:
– FLS
– Thermal Switch
This value is set for both the pumps in a two-pump station.
Protocol Select:
– None
– Modbus Slave
– AquaCom Slave
Slave Address Select and change to the correct value.
4. Complete the wizard.
Message Action
Confirmation
Apply Changes?
Current Settings will be overwritten
Confirm the settings.
Please wait...
Unit is rebooting with new configuration
Wait for the controller to restart.
The controller is ready to operate.
8.4 Common procedures
This section describes common procedures when working with the controller
setup and operation. For more information, see User Interface (page 39).
NOTICE:
The unit does not control the pump station during the restart
and upgrade processes. A backup method for level monitoring
and pump control may be required.
8.4.1 Modify the start and stop levels
This procedure is applicable when an analog sensor is used. Changes of the
start and stop levels are reflected in the current profile.
8 System Setup and Operation
30 Flygt FGC 400 Installation, Operation, and Maintenance