Xylem WTW OxiTop-i - 4.1.1 Display and Status Information

Operation OxiTop
®
(-i/-IDS)
12 ba77059e01 03/2019
4.1.1 Display
4.1.2 Status information
Status information in
the display
<M>  In the start display (ID...):
Display the measurement settings
(Info display BOD parameters)
 In the info display BOD parameters:
Start the measurement
 In menus/submenus/settings:
Take over the selection / entry,
Exit the menu/submenu and
go one level higher
<M_> Switch off the measuring head
(if a measurement is running, there is a security prompt
for confirmation)
<ENTER>  In the start display (ID...) / info display (BOD parame-
ters):
Open the menu for measurement settings
 In menus: Confirm selection / entry
<ENTER_> In the start display (ID...) / info display (BOD parameters):
Open the menu for system settings
< >  In menus: Navigation in the menu
 In the selection: change numerical values
<_ > Only for OxiTop
®
-IDS
Establish wireless connection to the meter
1 ID of the measuring head
2 Info on displayed measured value
3 Measured value
4 Date and time
2
4
3
BSB4.1 [mg/l]:
64.9
ID: 11
25.01.2019
08:22
1
Batteries almost empty.
Before starting a BOD measurement, exchange the batter-
ies (see section 5.1.1 E
XCHANGING THE BATTERY).
For suitable measures, see section 6 W
HAT TO DO IF...