15
16
使用中は皮膚の挟み込みに注意する。強く挟み込んだ状態で使用
しない。
ローラーは「つまむ」「離す」を繰り返しながら回転します。ローラーが
「つまむ」タイミングのときに、皮膚を挟み込みすぎないように、本体と
肌の角度を調節しながら使用してください。
力を入れて肌にこすりつけない。特に、首筋や二の腕などローラー
の間に肌が挟まりやすい部位に使用する場合は力を入れすぎない。
肌を傷める原因となります。
注意注意注意
Treatment
Treatment
The force of “pinching” between the rollers can be adjusted by
changing the angle of the device and direction of rolling.
Choose an angle that gives you the most comfortable treatment by
referring to the diagram below.
How to use on your skin
Skin
Rolling Direction Rolling Direction
Skin
Strong
Weak
Strong
Weak
Rollers
You w il l fe el t he
muscle stimulation
only while applying
the two rollers on
y o u r s k i n w h e n
using EMS mode.
* It may be difficult for the rollers to pinch the skin when it
is wet or with cosmetics applied. In this case, press the
rollers against your skin to adjust the force of pinching.
Treatment with the Rollers
Gently apply the rollers to your skin and then roll.
●
Turning on the power is not necessary if you wish
only to use the rollers.
●
Do not press too hard against your skin.
●
Always start rolling from down to up and from
center to outside when treating the face.
●
Always start rolling from down to
up and from outside towards the
center of your body when treating
the body.
Move the grip away from your skin,
adjust the angle, and then roll gently.
CAUTION
●
Be careful to not pinch your skin too hard when using the
device. Discontinue use if treatment is uncomfortable or
your skin gets pinched too tightly.
The rollers are designed to repeat a pinch-and-release action
when they are rolled. Avoid pressing too hard and carefully
maintain the angle when the rollers are in the “pinch” phase.
●
Do not press too hard on the skin, particularly over areas
where the skin is easily pinched such as the neck and
upper arms. Pressing too hard may harm your skin.
●
EMS Treatment
●
Eye Treatment (Micro-current)
Lamp changes to
solid Blue, Red, or
Purple to indicate
the EMS mode
Power / Mode
Button
Adjust to
Level 1-5
Level
Button
3
2
1
Press Power / Mode button for
more than 1 second to turn on the
power.
The Battery Power Lamp will turn on
and the EMS Mode / Level lamp will
turn to solid blue.
(Initially Face Mode Level 1.)
Press Power / Mode button again
for 1 second to select desired EMS
mode.
The EMS mode will change each time
you press the Power / Mode button.
For more information on the modes,
re fer to “ Sel ectin g E MS Mo des ”
(p.13)
Press Level button to adjust the EMS
intensity level.
The EMS intensity will change each time
you press the Level button.
Refer to “Adjusting the EMS Intensity
Level” on p.13 for details.
You may not feel the EMS stimulation if you have dry skin. Apply a
moisturizer or water to your skin if you feel the EMS is too weak.
* Do not use treatment oils as they may block EMS stimulation.
2
1
Press Power / Mode button for more
than 1 second to turn on the power.
●
Eye treatment mode will start when
power is turned on.
●
The Battery Level lamp will turn on and
the EMS Mode/Level lamp turns solid blue.
Place your thumb on one side of one
roller and apply the flat surface on the
tip of the other roller to your skin (see
p.18 for details).
●
Do not press too hard against your skin.
●
Start rolling from down to up, from the
center of your face outward.
Power / Mode
Button
Solid Blue
(Face Mode
Level 1)
Battery Level
(Solid White)
To Next Page
Loading...
