Start your Car
1. Please make sure that battery level is above
50% before you use it to jump start your car.
2. Insert the plug of the smart clip completely into
the jump starter, the green and red lights flash
alternately.
3. Correctly clip the red and black clamps to the
electrodes of the car battery (red to positive and
black to negative)(The green light stays on)
4. Start the vehicle.
5. When the vehicle is started, remove the
jumper cable from the vehicle battery immedi-
ately.
In any of the following situations, the smart clamp turns on protection
mode:
LED Indicator
The red/green led will flash
The green light is always on
Situations
Ready to work
Work status
support@ibuture.comsupport@yaberauto.com
EN
05
To Next Page
Loading...
