Yacht Devices YDEG-04 User Manual (English)

Questions and Answers:

M
Mark BlakeJul 29, 2025
What to do if Yacht Devices Boating Equipment is not displayed on the plotter and the NMEA 2000 network is red?
- A
  Adam TuckerJul 29, 2025
  If your Yacht Devices Boating Equipment's LED flashes every five seconds, but it's not displayed on the plotter, data isn't appearing, and the NMEA 2000 network state is red, here are a few things to try: * Treat the device connector with a spray for cleaning electrical contacts. * Try plugging the device into another connector. * Plug another device into the selected connector to verify it appears on the plotter. It could also indicate problems within the NMEA 2000 network itself, such as the network segment not being connected to the plotter or missing terminators.
J
Jordan NunezAug 6, 2025
How to troubleshoot Yacht Devices YDEG-04 when the LED doesn't signal after powering on the NMEA 2000 network?
- B
  Bethany JohnsonAug 6, 2025
  If the LED on your Yacht Devices Boating Equipment doesn't signal after powering on the NMEA 2000 network, try the following: * Ensure that the bus power is supplied. The NMEA 2000 network requires a separate power connection and cannot be powered by a plotter or another device connected to the network. * Clean the device connector with a spray designed for cleaning electrical contacts. * Try plugging the device into a different connector.
B
bernardnicoleAug 13, 2025
Why is my Yacht Devices YDEG-04 showing a red flashing light for the engine network status, and no data is appearing on the chart plotter?
- S
  Shawn LunaAug 13, 2025
  If the engine network status shows a red flashing light and no engine activity data appears on the chart plotter when the ignition is on, check the following: * Ensure the device's engine connector is connected to the correct connector. * If you've connected the device to a free connector, or instead of an existing device in a Volvo Penta EVC network, install the plug supplied with the device into a free connector. * Be aware that Volvo Penta EVC and J1939 networks use a speed of 250 kbps (used by default), BRP CAN networks.
P
pittsshannonAug 21, 2025
What to do if three red lights are flashing on Yacht Devices YDEG-04 Boating Equipment after inserting a memory card with YDEG.TXT?
- N
  Nicole CooperAug 21, 2025
  If you see three red lights flashing on your Yacht Devices Boating Equipment after inserting a memory card containing the YDEG.TXT file, the issue might be related to the card itself or the file. Here's what you can do: * The card may not be formatted correctly; reformat it. * The card may contain a logic error; reformatting is recommended even if scanning utilities don't detect errors. * The file may have the wrong extension; check and edit the file extension as needed.

Yacht Devices YDEG-04 Specifications

General

Device Type	NMEA 2000 Engine Gateway
NMEA 2000 Certification	Yes
PC Connection	USB
Water Protection	IP67
Current Consumption	30 mA
Supported Protocols	NMEA 2000

Yacht Devices YDEG-04 User Manual

Table of Contents

Questions and Answers:

Yacht Devices YDEG-04 Specifications