11
OPERATING INSTRUCTIONS CONT.:
ii) 12V Lead-Acid Battery Cold Mode is designed for 12V Lead-Acid and
AGM batteries with capacities higher than 50Ah being charged at cold
temperatures (below 10°C).
iv) 12V AGM Battery Normal Mode is designed for AGM / GEL batteries or
batteries with capacities higher than 50Ah being charged under normal
weather conditions.
v) 12V Repair Mode is designed for 12V LEAD-ACID BATTERIES ONLY.
It is a battery recovery mode for repairing & restoring damaged, stratied
and sulphated batteries. At Standby Mode, press and hold the MODE
button for 3 seconds to start battery repairing. The 12V REPAIR 1.5A
LED ashes and charging starts. The recovery process will take one
to four hours and the battery will be charged in 12V Lead-Acid Battery
Normal Mode if recovery is successful or STAND BY LED will be lighted
for failure.
i) 12V Lead-Acid Battery Normal Mode is designed for 12V Lead-Acid
batteries with capacities higher than 50Ah being charged under normal
weather conditions.
iii) 12V Lithium Battery Normal Mode is designed for 12V Lithium batteries
including Lithium Iron Phosphate (LiFePO4) batteries being charged
under normal weather conditions. PLEASE ENSURE THIS MODE IS
SELECTED FOR 12V LITHIUM BATTERIES ONLY.
vi) 12V Maintain Mode is designed for 12V Lead-Acid, AGM, GEL and
Lithium batteries being charged and maintained at 5A max. At Standby
mode, press and hold MODE button for 3 seconds, the 12V REPAIR
1.5A LED will be lighted and then press MODE button one more time to
enter 12V Maintain Mode.
vii) 12V Supply Mode works as a 12V DC power supply for powering 12V
devices or as memory retainer when replacing a battery. THIS FEATURE
WILL OVERRIDE SHORT-CIRCUIT AND REVERSE-POLARITY
PROTECTION. Disable these protection can cause sparks, re or
damage your charger and/or device connected if used improperly. DO
NOT USE THIS FEATURE FOR BATTERY CHARGING.
At Standby mode before connecting battery clamps to 12V device, press
and hold MODE button for 3 seconds, to enter the 12V Supply Mode. DO
NOT USE THIS FEATURE FOR BATTERY CHARGING.
5. While you are in 12V Charging Mode, press MODE once to cycle through the following charge modes.
To Next Page
Loading...