84 FT-857 Operating Manual
5. Initiate memory scanning; you will observe that the channels you marked to be skipped
are not included in the scanning loop.
6. Press the PTT switch to stop the scan; you may now use the SELECT knob to step
through the channels manually - one at a time - and you will observe that the “Skipped”
channels are, nonetheless, available for recall by manual means.
7. You may restore a previously-skipped channel to the scanning loop by selecting the
channel manually, then pressing the
[
B
](
SKIP
)
key momentarily so that the “dot” changes
to become a “hyphen.”
It is not possible to Skip Memory Channel M-001 (the Priority Channel). See the
next chapter for details on Priority operation.
SCANNING OPERATION
SCANNING OPERATION
To Next Page
Loading...
