INTRODUCTION
Yaesu FT-8800R Operating Manual (courtesy of W5JCK) Page 10 of 83
REV Key: while in Key Mode 2
• Press this key momentarily to reverse the transmit and receive frequencies on the
Main band during split-frequency (i.e. Repeater) operation.
• Press and hold in this key for ½ second to change the frequency shift direction:
RPT – (minus shift) RPT + (plus shift) RPT OFF (simplex)
TONE Key: while in Key Mode 2
• Press this key momentarily to change the Tone Squelch mode:
ENC (CTCSS Encoder) ENC.DEC (CTCSS Tone Squelch) DCS (DCS
operation)
SUB Key: while in Key Mode 2
• Press this key momentarily to activate the Sub band function (the icon will
blink on the Sub band). When the Sub band function is activated, any keys you press
act on the Sub band.
• When the Sub band function is activated (the icon is blinking on the Sub band),
press this key momentarily to deactivate the Sub band function.
(6) SET Key
• Press this key momentarily to enter the Set (Menu) mode.
• Press and hold in this key for ½ second to transfer the contents of the Main band VFO
into a Memory register.
To Next Page
Loading...
