Yaesu FT-8800R - Page 51

SCANNING
Yaesu FT-8800R Operating Manual (courtesy of W5JCK) Page 51 of 83
To Flag a Memory channel to be Scanned during Standard Memory
Scan:
 This is the default setting, so you only need to complete these steps if you
previously changed this setting for this Memory channel.
1. Set the radio to the Memory mode by pressing the key, if necessary.
2. Rotate the DIAL knob to select the channel which you wish to be scanned during
Standard Memory Scan.
3. Set the band for the selected Memory Channel to the Main band by pressing the DIAL
knob.
4. Press the SET key momentarily to enter the Set mode.
5. Rotate the DIAL knob to select Menu #37 SKP.MSM.
6. Press the DIAL knob momentarily, then rotate the DIAL knob to OFF.
7. Press and hold in the DIAL knob for ½ second to save the new setting and exit to
normal operation. 0.
To configure the FT−8800R for Standard Memory Scan:
 This is the default setting, so you only need to complete these steps if you
previously changed this setting. This setting is stored separately for each
side of each Hyper Memory channel (see page 43).
1. Press the SET key momentarily to enter the Set mode.
2. Rotate the DIAL knob to select Menu #35 SCAN M.
3. Press the DIAL knob momentarily, then rotate the DIAL knob to MEM.
4. Press and hold in the DIAL knob for ½ second to save the new setting and exit to
normal operation. 0.