Yaesu FT-8800R - Menu H 4 BAND; Menu #5 BEEP; Menu B 6 CLK.SFT

MENU (SET) MODE
Yaesu FT-8800R Operating Manual (courtesy of W5JCK) Page 71 of 83
Menu h 4 BAND
Function: Enables/disables the VFO Band edge for the current band.
Values:
BND. ON, BND.OFF
BND.
ON
When the VFO frequency reaches the high band edge of the current band,
the VFO frequency will jump to the low band edge of the current band (or
vice versa).
BND.OFF
When the VFO frequency reaches the high edge of the current band, the
VFO frequency will jump to the low band edge of the next band (or vice
versa).
Default:
BND. ON
 The value for this Menu Item is to be applied separately to each Hyper
Memory Channel.
Menu #5 BEEP
Function:
Enables/disables the beeper.
See Activate the Key/Button Beeper on page 21 for details.
Values:
BEP.ON, BEP.OFF
Default:
BEP.ON
Menu b 6 CLK.SFT
Function: Shifts the CPU clock frequency.
Values:
SFT. ON, SFT.OFF
Default:
SFT.OFF
 1. This function is only used to move a spurious response birdie, should it
fall on a desired frequency.
2. The value for this Menu Item is to be applied separately to each
Operating Band / Mode.