Yaesu FT-8800R - Menu B 33 RPT.MOD; Menu #34 SCAN; Menu B 35 SCAN M

MENU (SET) MODE
Yaesu FT-8800R Operating Manual (courtesy of W5JCK) Page 79 of 83
Menu b 33 RPT.MOD
Function: Sets the Repeater Shift Direction.
Values:
RPT.OFF, RPT. –, RPT. +
Default:
RPT.OFF (simplex)
 The value for this Menu Item is to be applied separately to each Operating
Band / Mode.
Menu #34 SCAN
Function: Selects the Scan-Resume mode.
See Set the Scan-Resume Preference on page 46 for details.
Values:
TIME, BUSY
TIME
Scanning will halt on a signal it encounters, and will hold five seconds. If
you do not take action to disable the scanning within five seconds, scanning
will resume even if the stations are still active.
BUSY
Scanning will halt on a signal it encounters. Two seconds after the carrier
has dropped because the other station(s) ceased transmission, scanning
will resume.
Default:
BUSY
 This Menu Item can be set independently for each band.
Menu b 35 SCAN M
Function: Selects the Memory Scan mode.
See Scan in Memory Mode on page 49 for details.
Values:
MEM, MSM
MEM
Enables Memory Scanning on all memory channels.
MSM
Enables Memory Scanning on flagged Memory Channels only.
Default:
MEM
 The value for this Menu Item is to be applied separately to each Operating
Band / Mode.