Maintenance and care
89
(2) Slide the rubber cover away from the ad-
juster, and then loosen the locknut.
(3) Adjust the free play by turning the adjust-
er.
(4) Hold the adjuster with one wrench while
tightening the locknut with another
wrench. Slide the rubber cover to its orig-
inal position.
(5) Install the front handlebar cover, and then
install the eight screws.
FX Cruiser High Output
(1) Remove the ten screws, and then re-
move the front and rear handlebar cov-
ers.
(2) Slide the rubber cover away from the ad-
juster, and then loosen the locknut.
(3) Adjust the free play by turning the adjust-
er.
(4) Hold the adjuster with one wrench while
tightening the locknut with another
wrench. Slide the rubber cover to its orig-
inal position.
1 Rubber cover
2 Locknut
3 Adjuster
4 Throttle lever free play
Throttle lever free play:
4.0–7.0 mm (0.16–0.28 in)
1 Front handlebar cover
2 Rear handlebar cover
1 Rubber cover
2 Locknut
3 Adjuster
4 Throttle lever free play
Throttle lever free play:
4.0–7.0 mm (0.16–0.28 in)
UF1X12E0.book Page 89 Thursday, June 14, 2007 10:24 AM
To Next Page
Loading...
Need help?
General