Yamaha MTN155 - Brake System Checks; Controls and Drivetrain Checks; Chassis and Running Gear Checks

For your safety – pre-operation checks
5-2
5
Rear brake
• Check operation.
• If soft or spongy, have Yamaha dealer bleed hydraulic system.
• Check brake pads for wear.
• Replace if necessary.
• Check fluid level in reservoir.
• If necessary, add specified brake fluid to specified level.
• Check hydraulic system for leakage.
7-21, 7-22
Clutch
• Check operation.
• Lubricate cable if necessary.
• Check lever free play.
• Adjust if necessary.
7-19
Throttle grip
• Make sure that operation is smooth.
• Check throttle grip free play.
• If necessary, have Yamaha dealer adjust throttle grip free play and lubricate ca-
ble end and grip housing.
7-16, 7-26
Control cables
• Make sure that operation is smooth.
• Lubricate cable ends if necessary.
7-26
Drive chain
• Check chain slack.
• Adjust if necessary.
• Check chain condition.
• Lubricate if necessary.
7-23, 7-25
Wheels and tires
•Check for damage.
• Check tire condition and tread depth.
• Check air pressure.
• Correct if necessary.
7-17, 7-18
Brake and shift pedals
• Make sure that operation is smooth.
• Lubricate pedal pivoting points if necessary.
7-26
Brake and clutch levers
• Make sure that operation is smooth.
• Lubricate lever pivoting points if necessary.
7-27
Sidestand
• Make sure that operation is smooth.
• Lubricate pivot if necessary.
7-28
ITEM CHECKS PAGE
UB7DE0E0.book Page 2 Tuesday, September 18, 2018 3:25 PM