Yamaha X-V2600 - Zone 2;Zone 3 Remote Control

CONTROLS AND FUNCTIONS
10
This section describes the function of each control on the
Zone 2/Zone 3 remote control used to control Zone 2 or
Zone 3.
The XM Satellite Radio controls (XM, DISPLAY, PRESET,
ALL, CAT., numeric buttons, NUMBER, cursor buttons
k / n / l / h and ENT) are only applicable to the U.S.A. model
and are operational only when XM is selected as the input source.
For details, see “Zone 2/Zone 3 remote control functions” on
page 55.
1 Input selector buttons
Select the desired input source of Zone 2 or Zone 3 and
change the control area.
2 PRESET +/–
Selects the preset station number (1 to 8) when TUNER is
selected as the input source or Zone 2 or Zone 3.
3 A/B/C/D/E
Selects the preset station group (A to E) when TUNER is
selected as the input source or Zone 2 or Zone 3.
4 ID1/ID2 switch
Switches the remote control ID between ID1 and ID2
(see page 106).
5 POWER
Turns on Zone 2 or Zone 3.
This button is operational only when MASTER ON/OFF on the
front panel is pressed inward to the ON position.
6 STANDBY
Sets Zone 2 or Zone 3 to the standby mode.
This button is operational only when MASTER ON/OFF on the
front panel is pressed inward to the ON position.
7 VOLUME +/–
Increases or decreases the volume level or Zone 2 or
Zone 3.
8 MUTE
Mutes the sound of Zone 2 or Zone 3.
Press again to restore the audio output to the previous
volume level.
9 ZONE 2/ZONE 3 switch
Switches between the operation mode of Zone 2 and that
of Zone 3.
Zone 2/Zone 3 remote control
Note
TUNER
1
CD
2
CD-R
3
DTV
4
CBL/SAT
5
MD/TAPE
6
VCR1
7
DVR/VCR2
8 9
0
POWER
STANDBY
+
–
+
–
PRESET/CH
A-E/CAT.
CAT.
A/B/C/D/E
MUTE
PRESET
VOLUME
ZONE 3ZONE 2 ID2ID1
PRESET
DISPLAY
ENT
0
XM
DVD
V-AU X
PHONO
ALL
k
k
k
k
NUMBER
1
3 8
2
7
6
5
4
9
(U.S.A. model)
Note
Note