Instrument and control functions
6-33
6
EAU14895
Adjusting the shock absorber
assemblies
WARNING
EWA10211
Always adjust both shock absorber
assemblies equally, otherwise poor
handling and loss of stability may re-
sult.
Each shock absorber assembly is
equipped with a spring preload adjust-
ing ring.
NOTICE
ECA10102
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Adjust the spring preload as follows.
Turn the adjusting ring in direction (a)
to increase the spring preload.
Turn the adjusting ring in direction (b)
to decrease the spring preload.
z Align the appropriate notch in the
adjusting ring with the position in-
dicator on the shock absorber.
z Use the spring preload adjusting
tool included in the kit to make this
adjustment.
EAUN3820
Power outlet
WARNING
EWAN0050
To prevent electrical shock or short-
circuiting, install the cap when the
power outlet is not in use.
NOTICE
ECAN0210
The accessory connected to the
power outlet should not be used
with the engine turned off, and the
load must never exceed 12 W (1 A),
otherwise the fuse may blow or the
battery may discharge.
This vehicle is equipped with a power
outlet located within storage compart-
ment A.
A 12-V accessory connected to the
power outlet can be used when the
main switch is in the “ON” position and
should only be used when the engine is
running.
To use the power outlet
1. Open storage compartment A.
(See page 4-9.)
2. Turn the main switch off.
1. Spring preload adjusting ring
2. Special wrench
3. Position indicator
Spring preload setting:
Minimum (soft):
1
Standard:
3
Maximum (hard):
5
1
2
3
4
5
2
1
(a)
(b)
3
To Next Page
Loading...
