Yamatake Azbil CMQ-V Series - Flow Set Value Data; Totalized Flow Related Data

23
Chapter 5. COMMUNICATION DATA TABLE
■ Flow set value
Note
• For RD and WD commands, the data is required four hexadecimal digits.
• The flow rate unit "L/min" becomes "mL/min" in MQV9200.
■ Totalized flow related data
Note
• For RD and WD commands, the data is required four hexadecimal digits.
Item Data range RAM EEPROM Remarks
Address RW Address
RW
Decimal Decimal
(Hexadecimal) (Hexadecimal)
Flow set value SP-0 (0 to 100%FS) 1401 ❍❍ 4401 ❍❍
L/min (0579) (1131)
Flow set value SP-1 (0 to 100%FS) 1402
❍❍ 4402 ❍❍
L/min (057A) (1132)
Flow set value SP-2 (0 to 100%FS) 1403
❍❍ 4403 ❍❍
L/min (057B) (1133)
Flow set value SP-3 (0 to 100%FS) 1404
❍❍ 4404 ❍❍
L/min (057C) (1134)
Flow set value SP-4 (0 to 100%FS) 1405
❍❍ 4405 ❍❍
L/min (057D) (1135)
Flow set value SP-5 (0 to 100%FS) 1406
❍❍ 4406 ❍❍
L/min (057E) (1136)
Flow set value SP-6 (0 to 100%FS) 1407
❍❍ 4407 ❍❍
L/min (057F) (1137)
Flow set value SP-7 (0 to 100%FS) 1408
❍❍ 4408 ❍❍
L/min (0580) (1138)
The value in the
data range (L/min)
is the value
removed decimal
point that obtained
by full scale flow
rate multiplied by
the percentage in
parentheses.
Item Data range RAM EEPROM Remarks
Address RW Address RW
Decimal Decimal
(Hexadecimal) (Hexadecimal)
Totalized flow event 0 to 9999 1601 ❍❍ 4601 ❍❍
setting lower 4 digits (0641) (11F9)
Totalized flow event 0 to 9999 1602 ❍❍ 4602 ❍❍
setting upper 4 digits (0642) (11FA)
Totalized flow lower 0 to 9999 1603 ❍❍ 4603 ❍❍
4 digits (0643) (11FB)
Totalized flow upper 0 to 9999 1604
❍❍ 4604 ❍❍
4 digits (0644) (11FC)
Same as RAM
address 2218 and
5218 in parameter
set up.
Same as RAM
address 2219 and
5219 in parameter
set up.
When resetting the
totalized value,
make sure to write
“0” for the both
lower and upper
digits.