■ Function setup related data
Note
• For RD and WD commands, the data is required four hexadecimal digits.
24
Chapter 5. COMMUNICATION DATA TABLE
Item Data range
RAM EEPROM
Remarks
Address
RW
Address
RW
Decimal Decimal
(Hexadecimal) (Hexadecimal)
Key lock Run 0: Key lock disabled 2001 ❍❍ 5001 ❍❍
1: Settings other than (07D1) (1389)
instantaneous SP and
integrated SP are key-
locked
2: All settings key-locked
RUN key operation 0: RUN key disabled 2002
❍❍ 5002 ❍❍
selection and (Operation starts in the (07D2) (138A)
operation mode control mode when the
selection when power is turned ON)
power turned ON 1: RUN key enabled (1)
(Operation is started up
in the operating mode
used before power shut-
down when the power
is turned ON)
2: RUN key enabled (2)
(Operation is started up
in the fully closed mode
when the power is turn-
ed ON)
Flow rate setup 0: Digital setup (set by key 2003
❍❍ 5003 ❍❍
method (SP setup operation or (07D3) (138B)
method selection) communications)
1: Analog setup (set by
external analog input
voltage)
Number of flow set 0: Number of SPs = 1 2004
❍❍ 5004 ❍❍
value selection (SP-0 only) (07D4) (138C)
(number of SPs 1: Number of SPs = 2
selection) (SP-0, SP-1)
2: Number of SPs = 3
(SP-0 to SP-2)
3: Number of SPs = 4
(SP-0 to SP-3)
4: Number of SPs = 5
(SP-0 to SP-4)
5: Number of SPs = 6
(SP-0 to SP-5)
6: Number of SPs = 7
(SP-0 to SP-6)
7: Number of SPs = 8
(SP-0 to SP-7)
Input range selection (1)Analog output selection 2005
❍❍ 5005 ❍❍
of analog setup is set at voltage output (07D5) (138D)
(analog SP input (C-06 = 0, 1, 4, or 5).
range selection) 0: 0 to 5V
internal
reference
input
1: 0 to 5V
external
reference
input
2: 1 to 5V
external
reference input
To Next Page
Loading...
