EasyManua.ls Logo

Yämmi 2 - SAFETY INSTRUCTIONS

Yämmi 2
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
46
SAFETY INSTRUCTIONS
02
Caution – Risk of burns! Do not touch hot surfaces of the product.
The product gives off heat during use.
Attention! Hot surface!
/ Do not use the appliance if it appears to be damaged.
/ Do not use the appliance if the power cord or plug are damaged.
/ Do not carry the appliance holding it by the power cord.
/ Let the appliance cool down before cleaning.
/ Do not move the appliance when it contains hot liquids, wait until it turns off automatically
or turn it off manually.
/ Do not touch the edges of the cutter blades.
/ If the blades are clogged with food, turn off the appliance before removing.
/ Keep the product and the appropriate power cord out of the reach of children.
/ Children must not play with the product.
/ This product should not be used by persons with reduced physical, sensory or mental capacities
or lack of experience and knowledge, unless they are supervised or instructed by someone respon-
sible for their safety about using the product safely and have understood the possible dangers.
/
This product is intended for domestic use and similar uses such as: work environments, such
as shops or offices; residential environments such as farms, motels or hotels (use by guests,
including in hotel rooms).
/
Do not go over the maximum capacity of the bowl/pan, to avoid hot splashes (or spilling of liquids).
/ If the power cord is damaged, it must only be replaced by the manufacturer, a service centre
or qualified technician.
/
Never immerse electrical parts of the product in water during either cleaning or operation.
Never leave the product under running water.
/ Make sure that you always plug the power plug into a grounded socket.
/
Disconnect the power cord from the electrical network through the respective plug only.
Do not pull on the cord.
/
Always disconnect the device from the power source if you leave it unattended, before assembling
or disassembling, cleaning or in the event of malfunction.
/ To avoid accident or injury, please follow the safety instructions.
/ When removing or inserting the blade, be very careful because the edges are very sharp. Never
hold the edges of the blade. Always handle it by holding the top. Allow the blade to cool after
cooking, before touching it.
/
Take care to avoid the spillage of food or liquid at the points of contact between the mixing
bowl and the machine base. If this should happen, clean immediately with a damp cloth and
dry completely before replacing the bowl on the machine base.
/ Improper use of the machine may cause severe injury.