3.2.5 Supply Cooling Water
Supply cooling water according to the
following procedures. Be sure to add
antirust or antifreeze to the cooling water.
1. Be sure to close the water drain cocks.
Note: The water drain cocks are opened
before shipping from the plant.
2. Remove the filler cap of the fresh water
cooler by turning the cap counterclock-
wise 1/3 of a turn.
23
GB
3. Operation
3.2.4 Supply Clutch Lube Oil
1. Remove the filler port cap at the top of
the bonnet, and fill with marine gear-
clutch- lube oil.
2. Fill with oil to the upper limit on the
dipstick. Insert the dipstick fully to
check the level.
Clutch oil capacity: See 2.2 Engine
Specifications
3. Tighten the filler port cap securely by
hand.
Do not overfill.
Overfilling will cause oil to be sprayed
out during operation and affect the
efficiency of the marine gear.
NOTICE
KMH4A Clutch
4JH3-TE series
Oil filler port cap
Upper limit/Lower limit
Dipstick
Fresh water Seawater
Filler cap Fresh water cooler
Dents Notches
JH-Turbo-Engels1b 28-06-2002 19:54 Pagina 23
To Next Page
Loading...
