Yanmar 4JH3-TE Series - Procedure

31
GB
3. Operation
3.3.6 Procedure
The following diagram shows the procedures for operation explained up to this point.
Parts of the operation may differ depending on the remote control system being used.
Accompanying operation manuals should be read carefully and understood.
Inspection Before
Starting
Starting the Engine
Driving Device Clutch
Clutch Remote Control
Lever
Starter Switch
 OFF  ON
 ON  START
ON
Alarm Lamps
Instrument Panel
Warming-up Operation
Speed Lever
Govenor Remote Control
Handle
Stopping the Boat/
Preparing to Stop the
Engine
Speed Lever
Govenor Remote
Control Handle
Driving Device Clutch
Clutch Remote Control
Lever
Speed Lever
Govenor Remote
Control Handle
Starting Operation
Driving Device Clutch
Clutch Remote Control
Lever
Speed Lever
Govenor Remote
Control Handle
Speed lever
Governor Remote
Control Handel
Driving Device Clutch
Clutch Remote Control
Lever
Speed Lever
Govenor Remote
Control Handle
Speed lever
Governor Remote
Control Handle
Cooling-down Operation
Engine Stop Button
Engine Stops
Engage Clutch
Forward or Reverse
Adjust Speed
Low Speed Position
1000rpm or lower
Forward or
Reverse
Adjust speed
Low Speed
Position
1000rpm or lower
For 5 mins. or longer
Low Speed
High Speed
Trawling
Trawling Handle
Trawling Lever
Return to Normal
Operation
Trawling Handle
Trawling Lever
Put in NEUTRAL
• Checking the Alarm
Devices
• Turn the key for no longer
than 15 secs. Remove
hand from key after
starting.
Checking for Problems
For 5 mins. or longer
Low Speed Position
1000rpm or lower for
5 mins. or longer
Checking the Engine
During Operation
Low Speed Position
1000rpm or lower
Put in Neutral
Low Speed High Speed
Racing the Engine
Repeat Several Times
KMH4A Clutch
JH-Turbo-Engels1b 28-06-2002 19:55 Pagina 31