Yanmar 6LY3 series - Installing the Engine Air Ducts; Installing the Engine Turbocharger

ENGINE
Assembling the Engine and Components
5-74 6LY3 Service Manual
© 2007 Yanmar Marine International
Installing the Engine Air Ducts
1. Fit the air duct (Figure 5-127, (4)) to the outlet
of the turbine with a gasket (Figure 5-127, (3))
and a V-clamp (Figure 5-127, (2)).
Figure 5-127
Figure 5-127
1 – Turbocharger
2–V-Clamp
3 – Gasket
4–Air Duct
5–Clamp
6–Hose
7 – Intercooler
8 – Air Flow from Turbocharger
2. Fit the air duct to inlet of the intercooler
(Figure 5-127, (7)) by using the hose
(Figure 5-127, (6)) and the clamp
(Figure 5-127, (5)).
Installing the Engine Turbocharger
1. Loosely assemble bracket “A”
(Figure 5-128, (4)) to bracket “B”
(Figure 5-128, (5)) using two M10 x 18 bolts.
Figure 5-128
Figure 5-128
1 – Turbocharger
2 – Mixing Elbow
3–Air Silencer
4 – Bracket “A”
5 – Bracket “B”
6 – Flywheel Housing
2. Install and finger tighten the two M10 x 22 mm
bolts in the engine.
3. Install the turbocharger (Figure 5-128, (1)) with
its attached oil line and loosely install two
M10 x 18 mm bolts through bracket “A” and into
the turbocharger.
(1)
(2)
(3)
(5)
(4)
(6)
(5)
(8)
(7)
0005829
0005830
(1)
(2)
(3)
(1)
(4)
(5)
2. Bolt, M10 x 18
3. Bolt, M10 x 18
1. Bolt, M10 x 22
(6)
0005831