Yanmar EF-494T - DISASSEMBLING THE FRONT BEARING CASE; DISASSEMBLING THE FRONT GEAR BOX

7 FRONT AXLE 7 FRONT AXLE
EF494T TM 06/2011 edition
163
7.4 DISASSEMBLING THE FRONT
BEARING CASE
(1) Remove the front wheels.
(2) Drain the front axle oil.
(3) Remove the nine M8 bolts.
(4) Put a bolt into the 3 places marked with an
asterisk. Tighten the bolts evenly to remove
the bearing case (A).
IMPORTANT
 The number of shims (B) and their positions
varies with each machine.
 When reassembling the front bearing case,
use the same number of shims, in the same
positions, as were found during disassembly.
7.5 DISASSEMBLING THE FRONT
GEAR BOX
Support the bearing case (A) using a garage jack,
and remove the knuckle arm (B) (2 x M12 bolts
and 2 x M12 nuts) and the bearing case.