Yanmar Lx410 - Every 200 Hours; Engine Oil; Change the Engine Oil and Engine Oil Filter

14. PERIODIC SERVICE
14-24
Lx410/450/490 Operator's Manual
14.Turn the starter key switch to START position.
15.Allow any trapped air to bleed from the fuel
system.
(A) Fuel shut-off valve
(B) Locking collar
(C) Sediment bowl
(a) OFF (closed) position
(b) ON (open) position
■ Engine Oil
Use engine oil with a viscosity that is appropriate for
use within the air temperature range:
● Wherein the tractor is scheduled to operate until
the next engine oil change.
Engine Crankcase
■ Change the Engine Oil and Engine Oil
Filter
1. Run the engine to warm up the engine oil.
2. Park the tractor safely and securely.
• For details, see "7. Safe Practices for Parking
the Tractor" on page 1-7.
3. Shut off the engine.
4. Chock all the tires safely and securely.
5. Allow the engine to cool down for several
minutes.
6. Raise the hood.
7. Place an oil pan underneath the engine oil drain
plug.
(A) Engine oil drain plug
v30_w_c5-n2
(a)
(b)
(A)
(B)
(C)
7. Every 200 Hours
Capacity Lubricant
Approximately
5.6 qt.
(5.3 L)
API Service Classifications CF
or higher
SAE 10W-30 or SAE 10W-40
IMPORTANT
Change the engine oil more frequently if the tractor
is used in extremely demanding conditions such as
the following:
● Extremely dusty conditions
● Frequent slow speed operation
● Frequent short trips
450140725
(A)