7-9
7. OPERATE THE ENGINE
Lx410/450/490 Operator's Manual
6. Push the 3-point hitch control lever forward to
lower any implements to the ground.
(A) 3-point hitch control lever
(a) Lowest position
(b) Highest position
(A) Implement control lever
(a) Lower the implement
7. Engage the parking brake securely, for details,
see "6. Lock and Set the Parking Brake" on page
7-4.
8. Pull the throttle control lever backward to the slow
idle position.
9. Idle the engine at least 2 minutes.
(A) Throttle control lever
10.Turn the starter key switch to the OFF position.
(A) Starter key switch
(a) OFF position
11.Remove the key from the starter key switch.
12.Before leaving the operator seat, ensure the
engine and all moving parts have stopped.
NOTE
● If the tractor is equipped with the implement
control valve:
• use the implement control lever to lower any
implements to the ground
IMPORTANT
● To prevent injury and property damage:
• always lock the parking brake
• make sure the primary gear lever, forward/N/
reverse lever and range gear lever are in the N
(neutral) positions
• make sure that the engine is not running
● The tractor wheels are free to move when any of
the following is in the N (neutral) position:
• primary gear lever
• range gear lever
• forward/N/reverse lever
3P_hitch_lever_3
(a)
(b)
(A)
To Next Page
Loading...
