Yardian YDN1602 - Stay Close to Device; Check LED Status; Reboot if Necessary; LED in Purple Warning

Please stay close to the Yardian device when
doing "Wi-Fi onboarding".
Check Yardian’s LED status. Yardian should
be in Wi-Fi AP mode to proceed (LED blinking
green and blue).
If Yardian is not blinking green and
blue, please press and hold the
Wi-Fi reset button for around 5
seconds and release when you see
the LED blinking green and blue.
If your Yardian is in Wi-Fi AP mode
for more than 15 minutes, you will
be asked to reboot Yardian (Press
Wi-Fi reset button until LED turns
red).
LED in purple!
SN :
MAC :
YID :
AA00754F
<MAC Number>
<Serial Number>
Press
24
Step 5.