5 support@yardistrystructures.com
PRE-ASSEMBLY:
•
•
•
POLYCARBONATE PARTS:
• Material may have sharp edges, wear safety gloves.
• Remove all plastic covering, on both sides of the polycarbonate panels,
directly before installing each piece.
• Place polycarbonate parts on a non-abrasive surface before and after
assembly as it can bend, dent and scratch easily.
• When standing on the outside of the unit, the notch in the polycarbonate
panel needs to be on the bottom right-hand side.
•
TAPE:
• Do not substitute tape.
• Tape should be applied in temperatures above 10
°
C (50
°
F).
DOUBLE SPRING TEMPERATURE CONTROLLER:
• Before installing, place black cylinder in the refrigerator for approximately 5-7
minutes or until cylinder rod has fully retracted.
• Automatic ventilation will not occur in temperatures above 50
°
C (122
°
F).
• The Double Spring Temperature Controller is designed to automatically open
and close with changes in temperature. It must not be opened or closed
manually. Doing so will result in damage to the component.
GUIDE SPACERS:
• Included to help align grooves in wood parts to properly install polycarbonate
panels.
WINTER AND HIGH WIND PREPARATION:
• Any accumulated snow must be removed from roof.
Assembly Tips
To Next Page
Loading...