13
Move to the opposite side. Using the long edge of the panel as a lever, move the panel side-to-side until the top
corner is ush to the oor frame . Secure panel with (2) 2" nails in the corners.
2
1
3
4
Continue securing the panel with 2" nails spaced 6" apart on edges and 12" apart inside panel.
Use a chalk line or use pre-painted grid lines to nail into joists under panel.
Check that the oor frame is square by measuring diagonally across the frame corners. If the measurements are
the same your oor frame is square. The measurement will be approximately 187-7/16" (298 cm).
Install (1) panel with the 48" edge and corner ush to the outside of the oor frame
and 3/4" along the oor joist. Use the GAA gauge block for the 3/4" measurement.
Secure panel with (2) 2" nails in the corners.
PARTS REQUIRED:
x1
5/8 x 48 x 96"
(1,6 x 121,9 x 243,8 cm)
x62
2" (5,1 cm)
FLOOR PANELS
3/4"
(1,9 cm)
2 Nails
2 Nails
BLOCK
GAUGE
BLOCK
3/4"
(1,9 cm)
6" (15,2 cm)
12" (30,5 cm)
Flush
Flush
GAUGE
BLOCK
120" (304,8) cm)
Flush
Flush
DOOR
To Next Page
Loading...