(3)
Any warranted part
that
is
scheduled
for
replacement
as
required maintenance in the
written
instructions must
be
warranted
for
the period
of
time prior
to
the first scheduled
replacement point
for
that
part.
If
the part fails prior
to
the
first scheduled replacement, the part must
be
repaired
or
replaced by YARDMAX according
to
Subsection
(4)
below.
Any such part repaired
or
replaced under warranty must
be
warranted
for
the remainder
of
the period prior
to
the first
scheduled replacement point
for
the part.
(4)
Repair
or
replacement
of
any warranted
part
under
the
warranty provisions must
be
performed
at
no charge
to
the
owner at a warranty station.
(5)
Notwithstanding
the
provisions
of
Subsection
(4)
above,
warranty
services
or
repairs must be provided
at
distribution
centers
that
are franchised
to
service
the
subject engine/equipment.
(6)
The owner must
not
be charged
for
diagnostic labor
that
leads
to
the determination
that
a warranted part
is
in fact
defective, provided
that
such diagnostic
work
is
performed
at a warranty station.
(7)YARDMAX
is
liable
for
damages
to
other
engine/
equipment components proximately caused by a failure
under warranty
of
any warranted part.
(8)
Throughout
the
emissions
control
system's
warranty
period
set
out
in
subsection
(b)(2),
YARDMAX
must
maintain a supply
of
warranted parts sufficient
to
meet
the
expected demand
for
such
parts
and
must
obtain
additional parts
if
that
supply
is
exhausted.
(9)
Manufacturer-approved replacement parts
that
do
not
increase
the
exhaust
or
evaporative
emissions
of
the
engine
or
emissions control system must be used in
the
performance
of
any warranty maintenance
or
repairs and
must
be
provided
without
charge
to
the
owner.
Such
use
will
not
reduce the warranty obligations
of
YARD
MAX.
(10) Add-on
or
modified parts
that
are
not
exempted by the
Air
Resources Board may
not
be used. The use
of
any
non-exempted add-on
or
modified parts will
be
grounds
for
disallowing a
warranty
claim. YARD
MAX
will
not
be
liable
to
warrant
failures
of
warranted parts caused by
the
use
of
a non-exempted add-on
or
modified part.
(11)
YARDMAX
issuing
the
warranty
shall
provide
any
documents
that
describe
that
warranty
procedures
or
policies
within
five
working
days
of
request by
the
Executive Officer.
e Emission Warranty Parts List
for
Exhaust
(1)
Fuel
Metering System
(i)
Carburetor
and
internal
parts
(and/or
pressure
regulator
or
fuel injection system).
(ii)
Air/fuel ratio feedback
and
control system.
(iii)
Cold start enrichment system.
(2)
Air
Induction System
(i)
Controlled hot air intake system.
(ii)
Intake manifold.
(iii)
Air
filter.
(3)
Ignition System
(i)
Spark
Plugs.
(ii)
Magneto
or
electronic ignition system.
(iii)
Spark advance/retard system.
(4)
Exhaust
Gas
Recirculation
(EGR)
System
(i)
EGR
valve body,
and
carburetor spacer
if
applicable.
(ii)
EGR
rate feedback
and
control system.
(5)
Air
Injection System
(i)
Air
pump
or
pulse valve.
(ii)
Valves affecting distribution
of
flow.
(iii)
Distribution manifold.
(6)
CatalystorThermal Reactor System
(i)
Catalytic converter.
(ii)
Thermal reactor.
(iii)
Exhaust manifold.
(7)
Particulate Controls
(i)
Traps,
filters, precipitators, and any other device
used
to
capture particulate emissions.
(8)
Miscellaneous Items
Used
in Above Systems
(i)
Electronic controls.
(ii) Vacuum, temperature, and
time
sensitive valves and
switches.
(iii)
Hoses,
belts, connectors,
and
assemblies.
25 I California And
Federal
Exhaust
And
Evaporative
Emissions
Control Warranty
Statement
To Next Page
Loading...
Need help?
General
