Yashica 8T2 - Unloading Film

(5) Insert end of film deep in the slot in the empty spool with
the side marked "1" facing up.
(6) Film must run along the white arrow-line film path marked
inside.
(7) Now holding both spools, place the loaded spool on the
upper spindle, the empty spool on the lower spindle, and
slip the
film along the arrow-path into the film gate. The
dull emulsion side
of the film must be facing the lens.
Note: The film gate automatically closes when the film
loading door is shut.
(8) Press the run-button to run the camera for 2 seconds as 0
test for smooth film movement through the camera. Theri.
close the film loading door and turn the lock clockwiSe
Run the camera until "0" appears in the footage counte,
window. The camera is now ready for filming.
UNLOADING FILM
See 16 page (~ame Ti ole)