Yashica FX-DQUARTZ - Key Component Removal Procedures; Shutter and Counter Base Plate Removal

- Pentagonal frame work
I
i_ FoM;og odi"•Hog w"hm
Fig. 6
Shutter Ass'y Removal:
(Mirror box ass'y must be removed)
(1) Remove the three shutter setscrews (61824522 x 2 and 61924022 x 1 ).
Two setscrews are located at the front upper part and one is located under the body light-proof
moquette. Then, pull
off the shutter upward.
~ Counter Base Plate Ass'y Removal:
( 1) Remove counter reverse lever spring ( 152870).
(2) Remove three setscrews (61923024x2
and 147816x1).
Then remove the counter
base plate be careful not to damage counter G-1.
(3) Remove counter G-1.
* When the head of counter G-1 is damaged, it skips two or three frames.
~Remarks for reassembling~
* Turn the notched section of counter G-1 in the opposite direction of the winding shaft.
* The counter position is the stop position of the winding shaft ass'y. Therefore, when assembling the
counter
base plate ass'y, it is necessary to pay attention to the above.
5