Yashica FX-DQUARTZ - Winding Base Plate Assembly Removal

Winding Base Plate Ass'y Removal:
(at bottom of the body)
Fig. 7
Counter reverse
lever spring
Counter
base
plate ass'y
Counter
Gear-1
Winding lever
shaft ass'y
(1) Remove the MD cap ring setscrew (the screw is counterclockwise) in the MD cap ring, which holds
the
MD cap ring:
(2) Remove the
SM. set lever fixer setscrew (61913024) and two connector base setscrews (61913024 x
2), remove the SM.
set lever fixer with the connector base by which the SM. set lever ass'y can be
removed.
(3) Remove the
set cam plate ass'y.
* The MD cap ring and the set cam plate ass'y are pressed in against the winding shaft.
Carefully
and gently twisting the MD cap ring and set cam plate ass'y so the hole should not be
made larger, separate them from the shaft.
* The SM. set lever, MD cap ring and the set cam plate ass'y are individual parts for composition,
the
SM. set lever is connected to the hole and joggle of the cam set plate ass'y.
(4) Remove anti-rewind collar setscrew (61814024). anti-rewind collar
and anti-rewind claw.
(5) Remove the three winding holder setscrews (63913024x3) the winding holder
with winding spring.
(at upper part
of the body)
(6) Remove two winding base plate ass'y setscrews (61813524x2) and shutter base plate post (162610),
the winding
base plate ass'y can be removed.
* To replace the sprocket and spool remove the winding base plate ass'y in the same way.
~ Winding Base Plate Mounting~
(at upper part of the body)
(1) Mount the winding base plate and the winding shaft.
6