YASKAWA DX100 - Playback from Reserved Start; Start Operation

4 Playback
4.5 Playback with Reserved Start
4-31
155507-1CD
RE-CSO-A037
DX100
4.5.2 Playback from Reserved Start
4.5.2.1 Start Operation
1. Set the mode switch to “PLAY”.
2. Press start button on the station.
– The job registered for the station starts up and the manipulator
performs one cycle operation.
NOTE
• While the job is being executed, the start button lamp on
the station lamps.
• If the workpiece must be prepared at the station, prepare it
before pressing the start button.
• During the execution of a job for one station, if the start
button of another station is pressed, the job of the latter
station is reserved and prepared to start. Jobs are
reserved and executed in the order that the start buttons
have been pressed.
• When a job is reserved, the start button lamp on the
station blinks.
• No station job is reserved when it is being executed even if
its start button is pressed.
• To suspend a job being executed, perform the Hold
operation.
SUPPLE-
MENT
Reservations are canceled when the start button is pressed
again during the job reservation operation.
220 of 554