YASKAWA DX100 - Page 337

6-97
155507-1CD
RE-CSO-A037
DX100
6 Convenient Functions
6.9 Parameter Setting Function
• BUZZER WHEN POSITION TEACHING (S2C433)
Refer to section 8.3.0.43 “S2C433: POSITION TEACHING
BUZZER” on page 8-28.
• STEP ONLY CHANGING (S2C203)
Refer to section 8.3.0.6 “S2C203: CHANGING STEP ONLY” on
page 8-13.
• RECT/CYL INDRICAL (S2C196)
Refer to section 8.3.0.2 “S2C196: SELECTION OF CARTESIAN/
CYLINDRICAL” on page 8-12.
• TOOL NO. SWITCH (S2C431)
Refer to section 8.3.0.42 “S2C431: TOOL NO. SWITCHING” on
page 8-28.
• TOOL NO. INTERLOCK FOR STEP ENTRY(S2C234)
Refer to section 8.3.0.29 “S2C234: STEP REGISTRATION AT
TOOL NO. CHANGE” on page 8-20.
• POS. TEACH ONLY JOG CONTROL GROUP (S2C320)
Refer to section 8.2.0.15 “S2C320: CONTROLLED GROUP JOB
TEACHING POSITION CHANGE” on page 8-7.
Setting Parameter Value
Consider 0
Not
Consider
1
Setting Parameter Value
Permit 0
Prohibit 1
Setting Parameter Value
Cyl. 0
Rectangle 1
Setting Parameter Value
Prohibit 0
Permit 1
Setting Parameter Value
Permit 0
Prohibit 1
Setting Parameter Value
Prohibit 0
Permit 1
337 of 554