YASKAWA DX100 - S3 C1111 to S3 C1190: ANALOG OUTPUT FILTER CONSTANT (When Analog Output Corresponding to Speed Function Is Used); S3 C1191: CUT WIDTH CORRECTION VALUE (When Form Cutting Function Is Used)

8-50
155507-1CD
RE-CSO-A037
DX100
8 Parameter
8.7 Parameters for Other Functions or Applications
8.7.0.7 S3C1111 to S3C1190: ANALOG OUTPUT FILTER CONSTANT (When
analog output corresponding to speed function is used)
By setting a constant to filter, a filter processing can be performed for the
output analog signal.
8.7.0.8 S3C1191: CUT WIDTH CORRECTION VALUE (When form cutting
function is used)
This parameter specifies the path correction value for pattern cutting
operation. A value 1/2 of the cut width is set in units of m.
481 of 554