YASKAWA DX100 - Executing the Display Allocation; Executing the I;O Control Allocation; Executing the Instruction;Output Control Allocation; Executing the Job Call Allocation

8 System Setup
DX100 8.15 Numeric Key Customize Function
8-112
– The instruction corresponding to the I/O control allocated by key
allocation (SIM) is displayed in the “ALLOCATION CONTENT”.
– The allocated instruction changes automatically when
“ALLOCATION CONTENT” is changed by key allocation (SIM).
Even if the I/O control allocation is changed to the default setting
allocated by the manufacturer with key allocation (SIM), the settings
for key allocation (EACH) remain the same.
8.15.5 Execution of Allocation
8.15.5.1 Executing the Instruction/Output Control Allocation
1. Press the key allocated for instruction allocation or output control
allocation.
– The allocated instruction is displayed in the input buffer line.
2. Press [INSERT] and [ENTER].
– The instruction displayed in the input buffer line is registered.
8.15.5.2 Executing the Job Call Allocation
1. Press the key allocated for the job call allocation.
– The CALL instruction is displayed in the input buffer line.
2. Press [INSERT] then [ENTER].
– The CALL instruction shown in the input buffer line is registered.
8.15.5.3 Executing the Display Allocation
1. Press the key allocated for the display allocation.
– The allocated display appears.
8.15.5.4 Executing the I/O Control Allocation
Alternate output allocation, momentary output allocation, pulse output
allocation, group output allocation (4-bit/8-bit), analog output allocation,
长沙工控帮教育科技有限公司
工控帮助教小舒QQ:2823408167